TIRE MANUFACTURING
Are you making tires or are you spending too much time cleaning molds instead?
Discover Starr Restoration Services, Inc. Dry ice Blasting (CO2 Cleaning) to handle your cleaning problems.
To produce a quality product that meets safety standards, tire molds should be cleaned on a regular basis. Mold fouling is a common problem all manufacturers face.
CO2 blast cleaning is more effective than traditional cleaning because the molds are cleaned while still hot and in the press. They are back in production in less time than it takes to cure 5 rounds. This allows more frequent cleaning and higher safety standards. CO2 blasting is aggressive enough to thoroughly clean the deep mold tread area and the dry ice pellets have the power because of its mass and density to open clogged micro vents.
Benefits:
- Increase production
- Reduce production cost
- Eliminates hand drilling of micro vents
- Meets OSHA safety standard
- Minimize re-stamping of sidewall lettering on aftermarket brand molds
- Attain near-zero defect levels in curing related blemishes and scrap
| |
Get the flash player here: http://www.adobe.com/flashplayer
|
|
|
